Victron Energy

● High efficiency With an efficiency of up to 94%, these chargers generate up to four times less heat compared to the industry standard. And once fully charged battery consumption is reduced to 0.5 watts, five to ten times less than the industry standard. ● Adaptive algorithm load of 6 stages: initial check-load-absorption-overhaul-float-storage The Blue Power charger features "adaptive" mana... Read more »

The Blue Power IP22 charger is the new professional battery charger with integrated Bluetooth. The Blue Power IP22 charger can be used in devices both in your workshop and in motor vehicles, as in cars (classics), motorcycles, boats and motor homes.   ● The battery is charged intelligently ... until the perfect conditions are met The seven-stage charging algorithm brings out the best... Read more »

The Battery Protect off non-essential loads before the battery is fully discharged (which would damage the battery) or before it runs out of enough charge to start the engine 12 / 24V self-regulated The BatteryProtect automatically detects the system voltage easy programming The BatteryProtect can be set to connect / disconnect to several different voltages. The seven-segment display will ind... Read more »

● The M6 eyelet connector with fuse is an accessory of the Blue Power IP65 Charger with DC connector. ● ATO fuse 30A Read more »

* Mobile phone not included ● Bluetooth Smart enabled The Blue Smart IP67 Battery Charger is thé wireless solution to monitor voltage and current, to change settings and to update the charger when new features become available. With Bluetooth, the functionality of the IP67 charger is enhanced and is similar to that of our IP22 and IP65 chargers. ● Completely encapsulated: waterproof, shockproo... Read more »

● The galvanic isolator consists internally of two diodes which are connected in anti-parallel fashion. When they are connected in this way, the diodes allow current in both directions but only above a certain threshold voltage. The voltage at which diodes conduct is about 1.4 Vdc. ● The isolator is installed directly behind your boat's 230V connection. The forward voltage from the ga... Read more »

● Use the MK3-USB to connect the following products to a computer for configuration: Multi MultiGrid MultiPlus Quattro Inverter (only models with a VE.Bus communication port) ECOmulti EasySolar EasyPlus Read more »

● Similarly to diode battery isolators, FET isolators allow simultaneous charging of two or more batteries from one alternator (or a single output battery charger), without connecting the batteries together. Discharging the accessory battery for example will not result in also discharging the starter battery. ● In contrast with diode battery isolators, FET isolators have virtually no voltage lo... Read more »

● The Cyrix Battery Combiner is a microprocessor controlled heavy duty relay that automatically connects batteries in parallel when one of them has reached a pre-set voltage (indicating that the battery is being charged), and disconnects when the voltage decreases below float level (indicating that one or more batteries are being discharged). Cyrix Battery Combiners are an excellent replac... Read more »

● The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine. ●  12/24V auto ranging The BatteryProtect automatically detects system voltage   ● Programming made easy The BatteryProtect can be set to engage / disengage at several diff... Read more »